Going to put together a build thread for my wife's XE Ghia.
Plans at this stage (subject to change!)
* Full re-spray (colour yet to be determined, but will be noticeable!)
* 19" Chrome Wheels
* EL/XH ECU to run the old X-Flow EFI 6
* Re-Trimmed Interior
* Update A/C pump
* Clear Front and Rear indicators
Some potential mods, but not as likely:
* BBM Manifold on the X-Flow
* BTR 4 Speed (not even sure if this is possible) or ADO 4 Speed
* 3.23/3.45 EF/EL rear end if the above goes ahead.
Current mods before we start are:
* Crappy, rusty, press bends Extractors
* 2 1/2" exhaust with Mandrel tailpipe (not too bad)
* Lowered Front and Rear Kings springs (not sure on specs)
Car is in good general condition, minimal rust. Little bit on each side at the lower rear roof turrets.
These Photos are as we brought and will be our starting point.
Reply With Quote
Bookmarks